Table of Contents
Advertisement
Cybernet Elite-4i User Guide
4.4.1.1 IDE Devices Sub-Menu:
Your computer has two IDE channels (Primary and Secondary) and each channel
can be installed with one or two devices (Master and Slave). Use these items to
configure each device on the IDE channel. Press Enter to display the IDE
sub-menu:
IDE HDD Auto-Detection
IDE Primary Master
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
áâßà Move Enter:Select +/-/PU/PD:Value F10:Save
F5: Previous Values
IDE HDD Auto-Detection:
Press <Enter> while this item is highlighted if you want the Setup Utility to
automatically detect and configure a hard disk drive on the IDE channel. If your
system has an IDE hard disk drive, you can use this utility to detect its parameters
and enter them into the Standard CMOS Setup automatically. If the auto-detected
parameters displayed do not match the ones that should be used for your hard disk
drive, you may change them as follows:
IDE Primary/Secondary Master/Slave: Change this to Manual.
Access Mode: Change this to LARGE, CHS or LBA.
Do not choose "Large" or "Normal" if the hard disk drive was already fully
formatted when you installed it. Select the mode that was used to format it.
IDE Primary/Secondary Master/Slave:
If you leave this item at "Auto," the system will automatically detect and configure
36
Phoenix – AwardBIOS CMOS Setup Utility
IDE Primary Master
[Press Enter]
[Auto]
[Auto]
80 GB
38309
16
0
38308
255
F6: Fail-safe defaults
Figure 35 IDE Primary Master Screen
Item Help
Menu Level >
To auto-detect the
HDD'S size head...on
This channel
ESC:Exit F1:General Help
F7:Optimized Defaults
C M O S S e t u p U t i l i t y
Advertisement
Table of Contents
