Installing The Cpu - Cybernet i-One Series H5 User Manual

CYBERNET LCD-PC i-One Series H5

Installing the CPU

NOTE: If you purchased your iOne Series H5 as a turn-key system, you must first follow
the instructions to remove the heat sink in order to be able to reach the CPU. Systems
purchased as „bare bones‟ require the installation of the heat sink which is shipped in the
accessories box with the unit.
4. Close the cover and the lever to complete
installation. Replace the heat sink.
NOTE: Any violation of the correct installation procedures may cause permanent
damage to your mainboard.
System Assembly
1. The socket has a plastic cap on it to protect
the pins from damage. This should remain
in place until actually installing a CPU.
2. Raise the plastic cap to reveal the socket
pins and open the cover by pushing down,
pulling out and up on the lever beside the
CPU socket.
Note: Do not touch the socket pins to avoid
damage.
3. Install the CPU after confirming the direction
for correct mating. Be sure to hold the CPU
by the edge of the CPU base.
Note: The CPU can only be installed in the
correct direction. Make sure the CPU pins are
completely embedded into the socket. If not,
take out the CPU with vertical motion and
reinstall.
Page 15