MOTO GUZZI B043157 Service Station Manual page 62

Maintenance
•
Keep the vehicle upright with both
wheels on the ground.
•
Unscrew and remove the level plug (4).
•
The level is correct if the oil is close to
the hole of the cap/dipstick (4).
•
If the oil is lower than specified, top-up
until it reaches the cap/dipstick hole
(4).
CAUTION
DO NOT ADD ADDITIVES OR OTHER SUBSTANCES TO
THE FLUID. WHEN USING A FUNNEL OR ANY OTHER EL-
EMENT, MAKE SURE IT IS PERFECTLY CLEAN.
See also
Removing the
rear wheel
Replacement
CAUTION
THE UNIT MUST BE HOT WHEN THE OIL IS CHANGED AS UNDER SUCH CONDITIONS OIL IS
FLUID AND THEREFORE EASY TO DRAIN.
NOTE
RIDE SOME km (miles) TO WARM UP ENGINE OIL
•
Place a container with an over 400 cm³
(25 cu.in) capacity under the drainage
plug (5).
•
Unscrew and remove the drainage
plug (5).
•
Unscrew and remove the breather cap
(3).
•
Drain the oil into the container; allow
several minutes for oil to drain out com-
pletely.
•
Check and if necessary, replace the
sealing washer of drainage plug (5).
•
Remove any metal scrap attached to
the drainage plug (5) magnet.
•
Screw and tighten the drainage plug
(5).
MAIN - 62
Moto Guzzi California 1400