Engine
•
Fit the gasket with the correct thick-
ness between the head and the cylin-
der.
•
Fit the right cylinder head.
•
Unscrew and remove the right chain
tensioner cap.
•
Screw two screws in the threaded
holes of the timing system upper gear.
•
Rotate the camshaft so that its pin is
aimed towards the hole in the timing
system chain.
•
Place the gear in the chain.
•
On the right camshaft pin, fit the hole
marked with the letter "R" of the timing
system gear.
•
Screw the cap of the right chain ten-
sioner.
•
Undo and remove the screws used to
place the gear on the camshaft.
•
Place the centrifugal separator align-
ing the reference pins with timing sys-
tem gear and so as to show the two
reference letters L - R parallel to the
direction of the chain, L left side, R right
side.
•
Insert the spacer.
•
Fix the centrifugal separator on the tim-
ing system gear using a screw with
Loctite on the thread.
•
Tighten the screw to the prescribed tor-
que.
ENG - 266
Moto Guzzi California 1400