MOTO GUZZI B043157 Service Station Manual page 116

Electrical system
Battery
Function
Electrically supply the vehicle: the YTX20-BS bat-
tery is already activated.
Level in electrical circuit diagram:
Battery recharge
Location:
•
on the vehicle: under the saddle
•
connector: on the battery
Electrical specifications:12 V / 18 Ah
Pin out:
1. Positive pole (red): approx. 12.6 V
2. negative pole (black): ground connection
DIAGNOSTICS INSTRUMENT: PARAMETERS
Battery voltage
•
Example value with key ON: 12.0 V
•
Example value with engine on: 14.2 V
In case of recovery, this value is set by the control
unit
Battery voltage pre Recovery
•
Example value with key ON: 12.0 V
•
Example value with engine on: 14.2 V
Value drawn from the signal read without taking
into account any recovery
CAUTION
BE CAREFUL WITH THE POSITIVE BATTERY CABLE - IT
HAS TO GO UNDER THE TOP OF THE FRAME.
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
DIAGNOSTICS INSTRUMENT: LOGIC ERRORS
Battery voltage P0560
•
too high/too low
Error cause
ELE SYS - 116
Moto Guzzi California 1400