Braking system
•
Remove the rubber protection cover
from the bleed valve.
•
Insert the transparent plastic pipe in
the rear brake calliper bleed valve and
insert the other end of this pipe into a
container to collect the fluid.
•
Remove the rear brake oil reservoir
cap.
•
Operate the brake lever and then open
the bleed valve on the calliper 1/4 of a
turn to let the air out.
•
Close the bleed again before reaching
the lever end of the stroke and repeat
the operation until there is no air.
•
Screw the bleeding valve and remove the pipe.
•
Top-up the reservoir until the correct brake fluid level is obtained.
•
Refit and lock the rear brake oil reservoir cap.
•
Refit the rubber protection cover.
BRAK SYS - 378
Moto Guzzi California 1400