Yamaha F200B Service Manual page 534

BRKT
Removing the tilt ram
Before removing the tilt cylinder, make
sure that the PTT rams are fully extended.
Otherwise, fluid could be expelled force-
fully from the PTT unit due to internal
pressure.
1. Remove the PTT motor assembly. See
"Removing the PTT motor" (9-45).
2. Remove the pipes 1 and 2.
3. Remove the circlip 3, shaft 4 and tilt
cylinder assembly.
3
1
4. Hold the tilt cylinder 5 in a vise.
5. Loosen the tilt cylinder end screw 6, and
then remove the tilt ram assembly.
Cylinder-end screw wrench 7:
90890-06568
6. Drain the fluid.
9-59
Bracket unit
4
2
7. Cover the tilt cylinder opening using a
rag 8, and then blow compressed air
through the hole a to remove the free
piston 9. WARNING! When removing
the free piston, never look into the tilt
cylinder opening because the free pis-
ton and PTT fluid could be expelled
forcefully.
Removing the trim ram
1. Hold the PTT body 1.
2. Loosen the trim cylinder end screws 2,
and then remove the trim ram assem-
blies.
Cylinder-end screw wrench 3:
90890-06568
7
3. Drain the fluid.
6
Disassembling the tilt ram
1. Hold the tilt ram end.
5
2. Remove the tilt piston bolt 1, and then
remove the tilt piston absorber valves 2.
8
a
1
9
2
3
2