Yamaha F200B Service Manual page 459

20. Repeat steps 12 and 13 to measure the
reverse gear backlash.
21. Check that the reverse gear backlash
average is within specification.
Reverse gear backlash:
0.43–0.96 mm (0.0169–0.0378 in)
TIP:
Adjust the shim thicknesses if the reverse
gear backlash is out of specification.
22. Remove the special service tools, handle
holder, spring, and outer plate cartridge.
23. Remove the propeller shaft housing
assembly, and then remove the washers
C. See step 1 in "Removing the propeller
shaft housing assembly" (8-16) and step
2 in "Removing the propeller shaft hous-
ing assembly" (8-73). (FL200B) See step
2 in "Removing the propeller shaft hous-
ing assembly" (8-22) and step 2 in
"Removing the propeller shaft housing
assembly" (8-79). (FL250G)
24. Install the propeller shaft housing assem-
bly. See step 2 in "Installing the propeller
shaft housing assembly" (8-84) and
steps 4 and 5 in "Installing the propeller
shaft housing
(FL200B) See step 2 in "Installing the
propeller shaft housing assembly" (8-84)
and steps 4 and 5 in "Installing the pro-
peller shaft housing assembly" (8-35).
(FL250G)
25. Install the cover, outer plate cartridge,
and water pump assembly. See "Install-
ing the water pump" (8-30). (FL200B)
See steps 1–3 and 5 in "Installing the
water pump" (8-30). (FL250G)
assembly" (8-29).
Shimming (counter rotation model)
8
8-96