Yamaha F200B Service Manual page 530

BRKT
Down-relief screw depth a
(reference data):
1.07–1.27 mm (0.042–0.050 in)
Up-relief screw height b
(reference data):
1.95–2.45 mm (0.077–0.096 in)
TIP:
• Install the screws E to the depth a and
height b that were measured before
removing them.
• If installing new parts, install them accord-
ing to the preceding reference data.
6. Install the filter F to the seal G.
7. Install the filters H, the spacers I, new
O-rings J, and the gear pump assembly
K.
8. Install the filter F, and then tighten the
gear pump bolts L to the specified
torque.
9. Install the manual valve M and circlip N,
and then tighten the manual valve to the
specified torque.
J
I
J
H
I
H
Gear pump bolt L:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
Manual valve M:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
10. Install the PTT motor. See "Installing the
PTT motor" (9-49).
9-55
Bracket unit
L
L
F
G
K
M
N
11. Check the hydraulic pressure. See
"Checking the hydraulic pressure" (9-38).
TIP:
If the hydraulic pressure is out of specifica-
tion, adjust the relief lock screws to adjust the
pressure.