Yamaha F200B Service Manual page 507

Removing the clamp bracket
1. Remove the PTT unit. See "Removing
the PTT unit" (9-37).
2. Remove the anode 1.
3. Remove the ground leads 2 and 3.
4. Remove the self-locking nut 4 and
through tube 5, and then disassemble
the clamp brackets 6 and 7.
2
3
4
7
1
5. Remove the trim sensor 8.
6. Remove the spring 9, hook 0, and pins
A.
7. Remove the tilt stop levers B and C,
5
6
Checking the clamp bracket anode
1. Check the anode. Replace if eroded.
8
Installing the clamp bracket
1. Assemble the distance collar assembly.
Distance a:
Clamp bracket and swivel bracket
9
0
distance collar assembly a, collar D,
and bushings E.
C
E
a
E
D
Clean if there is grease, oil, or scales.
NOTICE: Do not apply grease, oil, or
paint to the anode.
30.3–30.4 mm (1.193–1.197 in)
A A
E
B
a
9-32
9