Yamaha F200B Service Manual page 437

6. Remove the oil seals and needle bear-
ing. See steps 3 and 4 in "Disassembling
the propeller shaft housing assembly" (8-
16).
Checking the propeller shaft housing
1. Check the propeller shaft housing.
Replace if cracked or damaged.
2. Check the forward gear. Replace if
cracked or worn.
Checking the propeller shaft
1. Check the propeller shaft. Replace if
damaged or worn.
2. Measure the propeller shaft runout.
Propeller shaft runout:
0.02 mm (0.0008 in)
3. Check the dog clutch, shift rod joint, and
slider. Replace if cracked or worn.
Assembling the propeller shaft
housing assembly
• Use heat-resistant gloves. Otherwise,
a
• To prevent fires, remove any flammable
8
7
• Keep good ventilation while working.
Do not reuse a bearing, always replace it
6
with a new one.
1. Install a new needle bearing and oil
2. Install the original propeller shaft shims
TIP:
Do not reuse a shim if deformed or
scratched.
3. Install the propeller shaft housing 3 in
Propeller shaft housing (FL200B)
burns could result.
substances, such as gasoline and oil,
around the working area.
seals. See steps 1 and 2 in "Assembling
the propeller shaft housing assembly" (8-
18).
1 and thrust bearing 2.
2
1
the reverse direction.
3
8
8-74