Checking The Timing Belt; Installing The Timing Belt - Yamaha F200B Service Manual

POWR
TIP:
• When turning the timing belt tensioner,
apply a force of 15 N·m (1.5 kgf·m, 11.1
ft·lb) or less.
• Leave the pin inserted into the hole f of
the timing belt tensioner until the timing belt
is installed again.
10. Remove the timing belt 3 from the
driven sprocket
sprocket (STBD), and then remove it
from the crankshaft.
11. Remove the timing belt tensioner 4 and
pulleys 5.
4

Checking the timing belt

1. Check the interior and exterior of the tim-
ing belt. Replace if cracked, damaged, or
worn.

Installing the timing belt

1. Install the timing belt tensioner 1, collar
2, and pulley 3, and then tighten the
timing belt tensioner bolt a and pulley
bolt 4 to the specified torque.
7-39
Power unit
(PORT) or driven
3
5
5
a
1
Timing belt tensioner bolt a:
39 N·m (3.9 kgf·m, 28.8 ft·lb)
Pulley bolt 4:
39 N·m (3.9 kgf·m, 28.8 ft·lb)
2. Install the timing belt 5 onto the crank-
shaft so that part number b is in the
upright position and the belt position
mark c is aligned with the " " mark d
on the crankshaft. NOTICE: Do not
apply grease or oil to the timing belt.
d
4
3
2
5
b
c