Yamaha F200B Service Manual page 285

5
1
N
O
3
N
2
e
M
TIP:
Make sure to install the holder e and plastic
ties N in the order 1, 2, and so on.
29. Install the water pressure sensor coupler
G to the bracket.
30. Connect the cam position sensor coupler
(STBD IN) H and ignition coil couplers
(STBD) J.
31. Install joint coupler 1 L to the wiring har-
ness guide.
32. Install the air-fuel sensor coupler M to
the bracket.
33. Install joint coupler 2 N to the bracket.
34. Connect the knock sensor coupler R,
and then install the knock sensor coupler
to the engine ECM bracket.
K
e
K
e
L
K
L
J
H
G
35. Connect the ignition
(PORT) T, cam position sensor coupler
(PORT EX) U, and cam position sensor
coupler (PORT IN) Y.
36. Connect the engine ECM couplers Z.
NOTICE: Make sure that the rubber
seal is installed properly in each
engine ECM coupler.
37. Install the engine ECM P, and then
tighten the engine ECM bolts Q to the
specified torque.
Y
U
T
R
N
Engine ECM bolt Q:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
38. Install the fuel hoses and fuel rail covers.
See steps 7 and 9 in "Installing the fuel
injector" (6-46).
39. Connect the quick connectors. See "Con-
necting the quick connector" (6-8).
40. Install the intake manifold (PORT). See
"Installing the intake manifold" (6-18).
41. Install the intake silencer, and then con-
nect the air temperature sensor coupler
and blowby hose. See "Installing the
intake silencer" (6-19).
Wiring harness
coil couplers
Q
Z
P
Q
M
7
7-26