Yamaha F200B Service Manual page 206

ELEC
4. Remove the engine ECM cover.
5. Remove the engine ECM, and then dis-
connect the engine ECM coupler f.
f
6. Check the wiring harness for continuity.
a
f
e
2
Wiring harness continuity:
a Terminal 1–e Terminal 2
a Terminal 2–f Terminal 18
7. Connect the
NOTICE: Make sure that the rubber
seal is installed properly in the engine
ECM coupler.
8. Install the engine ECM, and then tighten
the engine ECM bolts to the specified
torque.
Engine ECM bolt:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
9. Install the engine ECM cover.
10. Connect the alert indicator coupler.
11. Install the trim sensor, and then connect
the trim sensor coupler.
5-77
Electrical system
1 2
18
engine ECM coupler.
12. Adjust the trim sensor. See "Adjusting
the trim sensor" (9-34).