Yamaha F200B Service Manual page 509

Self-locking nut B:
22 N·m (2.2 kgf·m, 16.2 ft·lb)
Grease nipple D:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
Friction plate screw G:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
12. Inject grease into the grease nipples until
grease comes out from the bushings f.
f
13. Adjust the trim sensor. See "Adjusting
the trim sensor" (9-34).
14. Install the PTT unit. See "Installing the
PTT unit" (9-41).
Adjusting the trim sensor
After tilting the swivel bracket up, make
sure to support it with the tilt stop lever.
Otherwise, the swivel bracket could sud-
denly lower.
1. Fully tilt the swivel bracket up, and then
support it using the tilt stop lever 1.
Clamp bracket and swivel bracket
1
2. Loosen the trim sensor screws 2.
3. Adjust the position of trim sensor, and
then tighten the trim sensor screws 2
temporarily.
TIP:
:
• To decrease the resistance, turn the trim
sensor cam in direction a.
• To increase the resistance, turn the trim
sensor cam in direction b.
4. Fully tilt the swivel bracket down.
5. Measure the trim sensor setting resis-
tance. Check that the resistance is within
specification.
Digital circuit tester: 90890-03174
2
b
a
c d
d
c
9-34
9