Roughing (Cycle 22, Din/Iso: G122, Software Option 19); Cycle Run - HEIDENHAIN TNC 620 User Manual

7.6 ROUGHING (Cycle 22, DIN/
ISO: G122, software option 19)

Cycle run

Use Cycle 22 ROUGHING to define the technology data for
roughing.
Before calling Cycle 22 you need to program further cycles:
Cycle 14 CONTOUR GEOMETRY or SEL CONTOUR
Cycle 20 CONTOUR DATA
Cycle 21 PILOT DRILLING, if necessary
Cycle run
1 The TNC positions the tool over the cutter infeed point, taking
the allowance for side into account.
2 In the first plunging depth, the tool mills the contour from inside
outward at the milling feed rate.
3 First the island contours (C and D in the figure at right) are
rough-milled until the pocket contour (A, B) is approached.
4 In the next step the TNC moves the tool to the next plunging
depth and repeats the roughing procedure until the program
depth is reached.
5 Finally, the tool retracts in the tool axis to the clearance
height or to the position last programmed before the cycle.
This depends on the parameter ConfigDatum, CfgGeoCycle,
posAfterContPocket.
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015
ROUGHING (Cycle 22, DIN/ISO: G122)
7
7.6
199