Please Note While Programming - HEIDENHAIN TNC 620 User Manual

Hide thumbs Also See for TNC 620:

Table of Contents

DATUM AT CENTER OF 4 HOLES (Cycle 418, DIN/ISO: G418) 14.12

Please note while programming:

Danger of collision!

If you set a datum (Q303 = 0) with the touch probe

cycle and also use probe in TS axis (Q381 = 1), then

no coordinate transformation must be active.

Before a cycle definition you must have programmed

a tool call to define the touch probe axis.

HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015