HEIDENHAIN TNC 620 User Manual page 386

15
Touch Probe Cycles: Automatic Workpiece Inspection
15.1 Fundamentals
Example: Measuring log for touch probe cycle 421:
Measuring log for Probing Cycle 421 Hole Measuring
Date: 30-06-2005
Time: 6:55:04
Measuring program: TNC:\GEH35712\CHECK1.H
Nominal values:
Center in reference axis:
Center in minor axis:
Diameter:
Given limit values:
Maximum limit for center in reference axis: 50.1000
Minimum limit for center in reference axis: 49.9000
Maximum limit for center in minor axis:
Minimum limit for center in minor axis:
Maximum dimension for hole:
Minimum dimension for hole:
Actual values:
Center in reference axis:
Center in minor axis:
Diameter:
Deviations:
Center in reference axis:
Center in minor axis:
Diameter:
Further measuring results: Measuring
height:
End of measuring log
386
50.0000
65.0000
12.0000
65.1000
64.9000
12.0450
12.0000
50.0810
64.9530
12.0259
0.0810
-0.0470
0.0259
-5.0000
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015