HEIDENHAIN TNC 620 User Manual page 397

15
MEASURE HOLE (Cycle 421, DIN/ISO: G421) 15.5
Measuring log Q281: Definition of whether TNC
should create a measuring log:
0: Create no measuring log
1: Create measuring log: The TNC will save the log
file TCHPR421.TXT by default in the directory that
also contains the associated NC program.
2: Interrupt the program run and display the
measuring log on the TNC screen. Resume program
run with NC Start.
PGM stop if tolerance error Q309: Definition of
whether in the event of a violation of tolerance
limits the TNC is to interrupt program run and output
an error message:
0: Do not interrupt program run, do not output an
error message
1: Interrupt program run and output an error
message
Tool for monitoring Q330: Definition of
whether the TNC is to monitor the tool (see
"Tool monitoring", page 388). Enter 0 to 32767 .9,
optionally the tool name with up to 16 characters
0: Monitoring not active
>0: Number or name of the tool the TNC used to
perform the operation with. You are able to apply a
tool via soft key directly from the tool table.
No. of measuring points (4/3) Q423: Specify
whether the TNC should measure the stud with 4 or
3 probing points:
4: Use 4 measuring points (default setting)
3: Use 3 measuring points
Type of traverse? Line=0/Arc=1 Q365: Definition
of the path function with which the tool is to move
between the measuring points if "traverse to
clearance height" (Q301=1) is active:
0: Move in a straight line between machining
operations
1: Move in a circular arc on the pitch circle diameter
between machining operations
397
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015