HEIDENHAIN TNC 620 User Manual page 331

Soft key Cycle
408 SLOT CENTER REF PT.
Measuring the inside width of a slot,
and defining the slot center as datum
409 RIDGE CENTER REF PT.
Measuring the outside width of a
ridge, and defining the ridge center as
datum
410 DATUM INSIDE RECTANGLE
Measuring the inside length and
width of a rectangle, and defining the
center as datum
411 DATUM OUTSIDE RECTANGLE
Measuring the outside length and
width of a rectangle, and defining the
center as datum
412 DATUM INSIDE CIRCLE
Measuring any four points on the
inside of a circle, and defining the
center as datum
413 DATUM OUTSIDE CIRCLE
Measuring any four points on the
outside of a circle, and defining the
center as datum
414 DATUM OUTSIDE CORNER
Measuring two lines from the
outside of the angle, and defining the
intersection as datum
415 DATUM INSIDE CORNER
Measuring two lines from within the
angle, and defining the intersection
as datum
416 DATUM CIRCLE CENTER
(2nd soft-key level) Measuring any
three holes on a bolt hole circle, and
defining the bolt-hole center as datum
417 DATUM IN TS AXIS
(2nd soft-key level) Measuring any
position in the touch probe axis and
defining it as datum
418 DATUM FROM 4 HOLES
(2nd soft-key level) Measuring 4
holes crosswise and defining the
intersection of the lines between
them as datum
419 DATUM IN ONE AXIS
(2nd soft-key row) Measuring any
position in any axis and defining it as
datum
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015
Page
334
338
341
345
348
353
357
362
366
370
372
376
Fundamentals 14.1
14
331