Overview; About These Instructions; Information On The Product; Software Module As A Supplement To The Basic Firmware - HEIDENHAIN PWT 101 User Manual

1
1.1

Overview

This chapter contains information about the product and this manual.
1.2

About these instructions

1.3

Information on the product

1.3.1

Software module as a supplement to the basic firmware

The block commutation module is a software module that can be run on a
PWT 101 in addition to the basic firmware.
This document describes software version 1278295-01 v1.0.1.
You can download the current version of the software module from
www.heidenhain.com.
1.3.2

Performance range of the software module

The software module allows you to conduct the following checks and make the
following settings:
Mounting Check
Output signals
Level display
Counts
Commutation offset
Encoder information
6
This User's Manual describes the functions provided by a
supplementary software module. The basic firmware of the product is
described in the Operating Instructions.
Please refer to the Operating Instructions as well as to the Installation
Instructions included with the product.
The Operating Instructions are available at www.heidenhain.com.
After the block commutation module has been loaded, the pin layout for
RENCO R35i/R35iL changes.
"RENCO R35i/R35iL pin layout", Page 41
Further information:
HEIDENHAIN | PWT 101 Block Commutation Module | User's Manual | 07/2021
Fundamentals | Overview