HEIDENHAIN TNC 620 User Manual page 411

Hide thumbs Also See for TNC 620:

Table of Contents

MEASURE INSIDE WIDTH (Cycle 425, DIN/ISO: G425) 15.9

Tool for monitoring Q330: Definition of

whether the TNC is to monitor the tool (see

"Tool monitoring", page 388). Enter 0 to 32767 .9,

optionally the tool name with up to 16 characters

0: Monitoring not active

>0: Number or name of the tool the TNC used to

perform the operation with. You are able to apply a

tool via soft key directly from the tool table.

Set-up clearance Q320 (incremental): Additional

distance between measuring point and ball tip.

Q320 is added to SET_UP (touch probe table), and

is only effective when the datum is probed in the

touch probe axis. Input range 0 to 99999.9999

Traversing to clearance height Q301: definition

of how the touch probe is to move between the

measuring points:

0: Move at measuring height between measuring

1: Move at clearance height between measuring

HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015