HEIDENHAIN TNC 620 User Manual page 48

1
Fundamentals / Overviews
1.2 Available Cycle Groups
Overview of touch probe cycles
The soft-key row shows the available groups of
cycles
Soft key Cycle group
Cycles for automatic measurement and compensation of workpiece
misalignment
Cycles for automatic workpiece presetting
Cycles for automatic workpiece inspection
Special cycles
Touch probe calibration
Cycles for automatic kinematics measurement
Cycles for automatic tool measurement (enabled by the machine tool
builder)
If required, switch to machine-specific touch
probe cycles. These touch probe cycles can be
integrated by your machine tool builder.
48
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015
Page
308
330
384
428
435
308
476