HEIDENHAIN TNC 620 User Manual page 405

15
MEASURE RECTANGLE INSIDE (Cycle 423, DIN/ISO: G423) 15.7
Measuring log Q281: Define whether the TNC
should create a measuring log:
0: Do not create a measuring log
1: Create a measuring log: The TNC saves the log
file TCHPR423.TXT as standard in the directory
TNC:\.
2: Interrupt program run and output measuring log
to the TNC screen. Resume program run with NC
Start.
PGM stop if tolerance error Q309: Definition of
whether in the event of a violation of tolerance
limits the TNC is to interrupt program run and output
an error message:
0: Do not interrupt program run, do not output an
error message
1: Interrupt program run and output an error
message
Tool for monitoring Q330: Definition of whether
the TNC is to monitor the tool (see "Tool
monitoring", page 388). Input range 0 to 32767 .9,
alternatively tool name with up to 16 characters
0: Monitoring inactive
> 0: Tool number in the tool table TOOL.T
405
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015