Installing The Intrusion Switch - Dell PowerEdge T330 Owner's Manual

1. Ensure that you follow the
2. Follow the procedure listed in
3. Remove the cooling shroud.
Steps
1. Disconnect the intrusion switch cable from the intrusion switch connector on the system board.
2. Press the intrusion switch and slide it out of the intrusion switch slot.
Figure 26. Removing the intrusion switch
1. intrusion switch slot
3. intrusion switch cable
Next steps
1. Install the intrusion switch.
2. Follow the procedure listed in
Related links
Removing the cooling shroud

Installing the intrusion switch

Installing the intrusion switch
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Ensure that you follow the
Safety instructions.
Before working inside your
After working inside your system
Safety instructions.
system.
2. intrusion switch
4. intrusion switch connector on the system board
.
69