Removing The Lcd Module - Dell PowerEdge T330 Owner's Manual

Figure 87. Installing the control panel board for systems with hot swappable hard drives
Next steps
1. Install the control panel assembly cover.
2. Install the control panel assembly.
3. Follow the procedure listed in the After working inside your system section.
Related links
Installing the control panel assembly cover
Installing the control panel assembly

Removing the LCD module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
4. Remove the control panel assembly.
5. Remove the control panel assembly cover.
Steps
1. Disconnect the LCD cable. Perform the following steps to disconnect the LCD cable:
a. Pull the retention tab that secures the LCD cable to the LCD cable connector on the control panel board.
b. Pull the LCD cable out of the LCD cable connector.
2. Remove the screw that secures the LCD module to the control panel.
3. Remove the LCD module out of the control panel assembly.
135