Table of Contents
Advertisement
Figure 73. Installing the PSU blank
1.
PSU blank
Replacing the power supply unit divider
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2.
If installed, remove the redundant power supply units (PSUs) or PSU blank.
Steps
1.
Remove the screw that secures the PSU divider to the chassis.
2.
Slide out the PSU divider and turn it clockwise to free the tabs on the PSU divider from the slots on the PSU cage.
3.
Slide the PSU divider out of the chassis.
4.
Align the tabs of the new PSU divider with the slots of the PSU cage.
5.
Turn the PSU divider counterclockwise and slide it in until the PSU divider is seated on the slots of the PSU cage.
6.
Tighten the screw to secure the PSU divider to the chassis.
2.
PSU bay
121
Advertisement
Table of Contents
Troubleshooting
