Installing the optional internal dual SD module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
Steps
1.
Locate the Internal Dual SD Module (IDSDM) connector on the system board.
2.
Align the IDSDM with the IDSDM connector on the system board.
3.
Push the IDSDM until it is firmly seated on the system board.
Figure 63. Installing the optional internal dual SD module
1.
Internal Dual SD module
3.
IDSDM connector
Next steps
1.
Install the SD card(s).
NOTE: Temporarily label each SD card with its corresponding slot before removal. Replace the SD card(s) into the
same slots.
2.
Follow the procedure listed in the After working inside your system section.
Related links
Installing an (optional) internal SD card
Heat sink and processor
2.
pull tab
109