Table of Contents
Advertisement
Figure 22. Removing the intrusion switch
Next steps
1.
Install the intrusion
switch.
2. Follow the procedure listed in
.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove system
cover.
4.
Remove air
shroud.
Steps
1. Align and slide the intrusion switch into the guide pin on the chassis.
2. Tighten the screw to secure the intrusion switch to the chassis.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
58
Installing and removing system components
After working inside your
Safety
instructions.
Before working on your
system.
system.
Advertisement
Table of Contents
