Intrusion Switch; Removing The Intrusion Switch - Dell PowerEdge T330 Owner's Manual

CAUTION: Do not operate the system with the cover removed for a duration exceeding 5 minutes.
NOTE: For proper seating of the cooling shroud in the system chassis, ensure that the cables inside the system are
routed along the chassis wall and secured using the cable securing clips.
Steps
1. Align the slots on the cooling shroud with the tabs on the internal cooling fan.
2. Lower the cooling shroud into the system until the slots on the cooling shroud are flush with the tabs on the internal cooling fan.
NOTE: When the cooling shroud is properly seated, the guide pin on the cooling shroud engages with the t-handle
post on the system board.
Figure 25. Installing the cooling shroud
1. touch point (2)
3. guide pin on the cooling shroud
Next steps
1. If removed, install the full-length PCIe card.
2. Follow the procedure listed in the After working inside your system section.

Intrusion switch

Removing the intrusion switch

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
68
2. t-handle post on the system board
4. slot (2)