2.
Keep the Phillips #2 screwdriver ready.
3.
Turn the system feet inward.
4.
Place the system on its side on a flat and stable surface.
Steps
Remove the screws that secure the system feet to the base of the tower.
Figure 14. Removing the system feet
1.
slot (12)
3.
tab (12)
5.
system feet (4)
Next steps
Installing the system feet.
Related links
Installing the system feet
Installing the system feet
Prerequisites
CAUTION: Installing the feet on a stand-alone tower system is necessary to provide a stable foundation for the system.
Failure to install the feet poses the risk of having the system tip over, possibly causing bodily injury or damage to the
system.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Keep the Phillips #2 screwdriver ready.
3.
Place the system on its side on a flat and stable surface.
Steps
1.
Align the tabs on the system feet with the slots on the base of the chassis.
2.
Secure the system feet to the base of the chassis by using the screws.
56
2.
screw hole (4)
4.
base of the tower
6.
screw (4)