Internal Usb Memory Key (Optional); Replacing The Optional Internal Usb Memory Key - Dell PowerEdge T330 Owner's Manual

3. arrow
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in the After working inside your system section.
Related links
Removing the cooling shroud
Installing the cooling shroud

Internal USB memory key (optional)

A USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. The USB
connector must be enabled by the Internal USB Port option in the Integrated Devices screen of System Setup.
To boot from the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in the
boot sequence in System Setup.
NOTE: To locate the internal USB connector (INT_USB) on the system board, see

Replacing the optional internal USB memory key

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Locate the USB connector or USB memory key on the system board.
NOTE: To locate the internal USB connector on the system board, see the System board connectors section.
2. If installed, remove the USB memory key from the USB connector.
3. Insert the replacement USB memory key into the USB connector.
Figure 50. Removing the internal USB memory key
1. USB memory key
4. internal cooling fan
System board jumpers and
2. USB port
connectors.
95