Table of Contents
Advertisement
Figure 25. Removing the intrusion switch
Next steps
Replace the intrusion
switch.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
2. Follow the procedure listed in the
Before working inside your
system.
Steps
1. Align and slide the intrusion switch in the slot until it is firmly seated in the slot on the system.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
2. Connect the intrusion switch cable to the connector on the system board.
36
Installing and removing system components
Advertisement
Table of Contents
