Installing The Control Panel Board - Dell PowerEdge T330 Owner's Manual

Steps
1. Remove the screws that secure the control panel board to the control panel.
2. Lift the control panel board until the control panel board disengages from the slots on the control panel.
3. Slide the control panel board toward the back of the control panel, and lift the control panel board away from the control panel.
Figure 86. Removing the control panel board for systems with hot swappable hard drives
1. control panel board
Next steps
1. Install the control panel board.
2. Follow the procedure listed in the After working inside your system section.
Related links

Installing the control panel board

Installing the control panel board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Align the control panel board with the control panel.
CAUTION: Take care not to damage the mylar covering the ID switch.
2. Slide the control panel board toward the front of the control panel to lock the slide tabs and the screw holes into the respective
slots on the control panel.
3. Tighten the screws to secure the control panel board to the control panel.
134
2. screw (3)