System Battery - Dell PowerEdge T330 Owner's Manual

Steps
1. Align the slots on the power interposer board (PIB) with the hooks on the power supply unit (PSU) cage and slide the PIB until
it snaps into place.
2. Route the power cables through the securing clips as applicable, and connect the power cables to the system board.
Figure 78. Installing the power interposer board
1. release latch
3. slots (4)
Next steps
1. Install the cooling shroud.
2. Install the PSUs or PSU blank.
3. Follow the procedure listed in the After working inside your system section.
Related links
Installing the cooling shroud
Installing a redundant AC power supply unit
Installing the power supply unit blank

System battery

The system battery is used to power the real-time clock and storing the BIOS settings of the system.
2. hooks (4)
4. PIB connector
127