Removing The Optional Front Bezel; System Feet; Removing The System Feet - Dell PowerEdge T330 Owner's Manual

3. bezel key
5. bezel tab (2)

Removing the optional front bezel

Steps
1. Unlock the bezel by using the bezel keys.
NOTE: There are two bezel keys attached to the back of the bezel.
2. Press the release latch at the top of the bezel.
3. Pull the top end of the bezel away from the system.
4. Unhook the bezel tabs from the slots at the bottom of the system board, and pull the bezel away from the system.
Figure 13. Removing the front bezel
1. bezel key
3. release latch
Next steps
Install the optional front bezel.

System feet

The system feet provide stability to the system in the tower mode.

Removing the system feet

Prerequisites
NOTE: It is recommended that you remove the system feet only when you are converting the system from the tower
mode to the rack mode, or when you are replacing the system feet with the wheel assembly.
1. Follow the safety guidelines listed in the Safety instructions section.
4. slot on the chassis (2)
6. bezel
2. bezel
4. system
55