Next steps
Removing the optional internal dual SD module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Locate the Internal Dual SD Module (IDSDM) on the system board.
4.
If installed, remove the SD card(s).
Steps
Hold the pull tab and pull the IDSDM out of the system.
Figure 62. Removing the internal dual SD module (IDSDM)
1.
IDSDM
3.
IDSDM connector
Next steps
1.
Install the internal dual SD module.
2.
Install the cooling shroud.
3.
Follow the procedure listed in the After working inside your system section.
Related links
Removing an (optional) internal SD card
Installing the optional internal dual SD module
108
2.
pull tab