Installing The Lcd Module - Dell PowerEdge T330 Owner's Manual

Figure 88. Removing the LCD Module
1. LCD module
3. LCD cable connector
5. screw
Next steps
1. Install the LCD module.
2. Follow the procedure listed in the After working inside your system section.
Related links
Removing the control panel assembly
Removing the control panel assembly cover

Installing the LCD module

Installing the LCD module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Align the LCD module with the LCD module slot and insert the LCD module into the control panel.
2. Tighten the screw to secure the LCD module to the control panel.
3. Insert the LCD module cable into it's connector on the control panel board and push the retention tab in to secure the cable.
136
2. retention tab
4. LCD cable