Non-Redundant Ac/Cabled Power Supply Unit - Dell PowerEdge T330 Owner's Manual

Figure 74. Removing and installing the PSU divider
1. PSU divider
3. screw
Next steps
1. Install the redundant PSUs or PSU blank as applicable.
2. Reconnect the system to its electrical outlet and power on the system, including any attached peripherals.
Related links
Removing a redundant AC power supply unit
Removing the power supply unit blank
Installing a redundant AC power supply unit
Installing the power supply unit blank

Non-redundant AC/cabled power supply unit

Your system supports a non-redundant 350 W AC power supply unit (PSU).
NOTE: When selecting or upgrading your system configuration, verify the system power consumption with the Dell
Energy Smart Solution Advisor at Dell.com/ESSA to ensure optimum power utilization.
Removing a cabled power supply unit
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
122
2. tabs (4)