Installing The Optional Internal Dual Sd Module; Integrated Storage Controller Card - Dell PowerEdge R530 Owner's Manual

Installing the optional internal dual SD module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
NOTE: Temporarily label each SD card with its corresponding slot before removal.
Steps
1 Locate the internal dual SD module (IDSDM) connector on the system board. To locate the IDSDM connector, see the System board
connectors section.
2 Align the IDSDM with the connector on the system board.
3 Push the IDSDM until it is firmly seated on the system board.
Figure 53. Installing the optional internal dual SD module
1 IDSDM
3 IDSDM connector
Next steps
1 Install the SD cards.
NOTE: Re-install the SD cards into the same slots based on the labels you had marked on the cards during removal.
2 Follow the procedure listed in the After working inside your system section.

Integrated storage controller card

Your system supports an integrated storage controller card that provides the integrated storage subsystem for your system's internal hard
drives. The controller supports SAS/SATA and SSD drives and also enables you to set up the hard drives in RAID configurations as
supported by the version of the storage controller included with your system.
114 Installing and removing system components
2 pull tab