Table of Contents
Advertisement
Figure 54. Removing the optional IDSDM module
Next steps
Install the
IDSDM.
Installing the optional internal dual SD module
Prerequisites
Follow the safety guidelines listed in
NOTE:
You must install either the Internal dual SD module (IDSDM) or the BOSS M.2 card in the same IDSDM/BOSS
M.2 connector.
NOTE:
The procedure to install IDSDM and the BOSS M.2 card is the same.
Steps
1. Holding both ends of the IDSDM, insert the IDSDM into the IDSDM/BOSS M.2 connector on the system board.
NOTE:
For information on the location of the IDSDM/BOSS M.2 connector, see the
connectors
section.
2. Push the release tab that secures the IDSDM to the system board, in place.
3. Using the Phillips #2 screwdriver, tighten the retention screw that connects the internal dual SD module (IDSDM) to the system
board.
90
Installing and removing system components
Safety instructions
on page 45.
System board jumpers and
Advertisement
Table of Contents
