Parameter Display Mask - FE PXR4 Operation Manual

to
to
[Description]
• This parameter skips the parameter display by items.
• This parameter is used not to display the items that are
not used, or not to change the settings mistakenly.
[Setting example 1] Skipping "I" and "d"
Setting "4+8=12" according to the code table of dSP3
Display
1.
2.
3.
4.
5.
6.
[Setting example 2] Extinguishing the PV display
Reducing 64 from parameter dP13
1.
2.
3.
[Setting example 3] Displaying the PV display (factory default)
Adding 64 to a value of parameter dP13
1.
2.
3.
1.800.561.8187
78
Parameter display mask (Setting range: 0 to 255)
Press and hold the key for five seconds.
SEL
will be displayed on the PV display.
Press the key to display
Press the key once.
SEL
The current setting ( ) flashes on the SV display.
Press the or keys to display
Press the key once.
SEL
parameters of and will be skipped, and will not be displayed.
If you want to display the operation status, press and hold the
Display parameter .
Check a currently displayed value of
(Example: When a value of
Re-set the result of calculation obtained from Step 2 to
Display parameter .
Check a currently displayed value of
(Example: When a value of
Re-set the result of calculation obtained from Step 2 to
www.
• "Parameter mask DSP" in "2-1 Parameter list" (pages 7
to 11) shows which parameter is skipped by setting
to and
• Set the total value of the item codes that you want to skip.
Operating procedure
.
.
will stop flashing and will be registered for
Operating procedure
and reduce 64 from the value.
is 127, 127-64=63).
Operating procedure
and add 64 to the value.
is 63, 63+64=127).
.com
to .
. After that, the
key for two seconds.
SEL
. (Example: Set 63 to
. (Example: Set 127 to
information@itm.com
).
).