Hys (Hysteresis) Mode At On/Off Control - FE PXR4 Operation Manual

HYS (Hysteresis) mode at ON/OFF control (Settings: oFF/on)
[Description]
• This parameter is used for selecting the hysteresis opera-
tion mode at ON/OFF control.
: Starts the ON/OFF control at the values of
HYS
SV+ and SV-
2
:
Starts the ON/OFF control at the values of
SV and SV+HYS, or SV and SV-HYS.
• Default setting: ON
[Setting example] Setting the hysteresis mode to ON
Display
1.
2.
3.
4.
5.
6.
1.800.561.8187
36
HYS
.
2
Press and hold the SEL key for three seconds.
will be displayed on the PV display.
Press the key to display
Press the key once.
SEL
The current setting ( ) flashes on the SV display.
Press the key to display
Press the key once.
SEL
controller will operate with the hysteresis being as shown in the figure of ON above.
If you want to display the operation status, press and hold the
www.
onoF : OFF
Operating procedure
.
.
will stop flashing and will be registered for
.com
onoF : ON
HYS HYS
SV
HYS
HYS
SV SV
. After that, the
SEL key for two seconds.
information@itm.com
SV