FE PXR4 Operation Manual page 51

Parameter
display symbol
to
to
[MODE code list]
MOD
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Power-on
start
PV
1.800.561.8187
Name
Current program
STAT
status
1st to 8th
SV-1
target SV
to
SV-8
1st to 8th ramp
TM1r
segment time
to
TM8r
1st to 8th soak
TM1s
segment time
to
TM8s
Ramp-soak mode
Mod
Power-on start Output at the END
Output at OFF
OFF Continuous control Continuous control
OFF Continuous control
Continuous control
OFF Continuous control Standby mode
OFF Continuous control Standby mode
OFF Standby mode
Continuous control
OFF Standby mode Continuous control
OFF Standby mode
Standby mode
OFF Standby mode Standby mode
ON Continuous control Continuous control
ON Continuous control Continuous control
ON Continuous control Standby mode
ON Continuous control
Standby mode
ON Standby mode Continuous control
ON Standby mode Continuous control
ON Standby mode Standby mode
ON Standby mode Standby mode
Can be repeated
SV-2
2nd soak
3rd ramp
2nd ramp
SV-1
2st soak
1st ramp
TM1r TM1S TM2r TM2S TM3r TM3S TM4r TM4S
www.
Description
Displays the Ramp-soak current status.
This parameter is only for display, and cannot set anything.
: OFF
to : Under the 1st to 8th ramp operation
to : Under the 1st to 8th soak operation
: Ends the program
Sets the target value (SV) of each ramp segment
(Setting range: to )
Sets the ramp time for each segment
(Setting range: 0 to 99h 59min)
Sets the soak time for each segment
(Setting range: 0 to 99h 59min)
Selects the modes of ramp-soak function.
Set to "0" under normal conditions
[Description of functions]
1. Power-on start: The ramp-soak operation starts to run
Repeat operation
OFF
ON
2. Output at END: The output status at the END of the
OFF
ON
OFF
3. Output at OFF: The output status while the ramp-soak
ON
OFF
4. Repeat operation: This function makes the ramp-soak op-
ON
OFF
ON
OFF
ON
OFF
ON
* Standby mode:
OFF
ON
[Ramp]
The segment in which the set value changes toward the tar-
SV-4
get value.
4th soak
[Soak]
The segment in which the set value is always the target value
4th ramp
and remains unchanged.
SV-3
3rd soak
.com
Factory
default settings
0%FS
0.00
0.00
0
from the current PV value.
ramp-soak operation.
operation is set to OFF.
eration to continue after one cycle of ramp-soak opera-
tion is completed. At the event of Repeat operation: OFF,
the SV that is set in the final cycle is kept.
Output: control output OFF or -3%
Alarm: OFF
Control: OFF
information@itm.com
Remark
No
symbol
appears
when
the
ramp-soak
model
is not
selected.
51