Output Offset Value; Anti-Reset Windup - FE PXR4 Operation Manual

Output offset value (Setting range: -100.0 to 100.0 %)
Anti-reset windup (Setting range: 0 to 100%FS)
[Description]
• The anti-reset windup (
optimum value by the auto-tuning operation.
By setting , the amount of overshoot can be adjusted.
[Note]
By making use of the fuzzy control system equipped with
PXR, the amount of overshoot can be minimized without
setting and
[Setting example] Changing the anti-reset windup from 60˚C to 80˚C.
Display
1.
2.
3.
4.
5.
6.
1.800.561.8187
30
) is automatically set to an
.
Press and hold the SEL key for three seconds.
will be displayed on the PV display.
Press the key to display
Press the key once.
SEL
The current setting ( ) flashes on the SV display.
Press the or keys to display
Press the key once.
SEL
controller will operate with the anti-reset windup being 80˚C.
If you want to display the operation status, press and hold the
www.
PV
AR value
SV
AR value
Operating procedure
.
.
will stop flashing and will be registered for
.com
}
In this range, the integral
operation is not performed.
}
In this range, the integral
operation is performed.
}
In this range, the integral
operation is not performed.
. After that, the
SEL key for two seconds.
information@itm.com