Upper And Lower Limits For Control Output 1; Upper And Lower Limits For Control Output 2 - FE PXR4 Operation Manual

,
,
[Description]
• These parameters set the limit value of output.
Upper limit
OUT1 PHC1
PHC2
OUT2
• How the output is limited (maintained within the limit or
breaks the limit) is set in the parameter of
• When flammability is controlled by turning the gas on
and off, this function can avoid flashing.
(Minimum ON pulse width [seconds] ) =
(Minimum OFF pulse width [seconds] ) =
: Cycle time
[Setting example] Changing the lower pulse width limit from 20.0% to 10.0%
Display
1.
2.
3.
4.
5.
6.
1.800.561.8187
62
Upper and lower limits for control output 1 (Setting range: -3.0 to 103.0%)
Upper and lower limits for control output 2 (Setting range: -3.0 to 103.0%) (Option)
Lower limit
PLC1
PLC2
100
×
TC
×
100
Press and hold the SEL key for five seconds.
will be displayed on the PV display.
Press the key to display
Press the SEL key once.
The current setting ( ) flashes on the SV display.
Press the or keys to display
Press the SEL key once.
controller will operate with the output lower limit being 10%.
If you want to display the operation status, press and hold the
www.
30 (seconds)
PHC
Output
PLC
0
.
Related parameters:
100
TC
Operating procedure
.
.
will stop flashing and will be registered for
.com
(TC= 30 seconds)
Input 100(%)
(page 37)
(page 63)
. After that, the
key for two seconds.
SEL
information@itm.com