FE PXR4 Operation Manual page 52

• The segment in which both the ramp time and soak time
are set to "0" is skipped.
[Ex]
SV-1: 50
TM1r:0.10
TM1S:0.05
• The SV limit function is valid even while the ramp-soak
operation is running.
Although the set value (SV-n) remains unchanged, the
SV under ramp-soak operation is affected by the limit
function. Therefore, the pattern is as shown in the figure
on right, and it may not change according to the original
set time.
[Setting example] Setting the 1st target SV to 400°C
Display
1.
2.
3.
4.
5.
6.
1.800.561.8187
52
SV-2:200 SV-3:100
TM2r:0.00 TM3r:1.00
TM2S:0.00 TM3S:0.75
Press and hold the key for three seconds.
SEL
will be displayed on the PV display.
Press the key to display
Press the SEL key once.
The current setting ( ) flashes on the SV display.
Press the key to display
Press the key once.
SEL
If you want to display the operation status, press and hold the
www.
200
100
50
PV
TM1r TM1S
SV-1
SV-2
PV
SV-3
TM1r TM1S
Operating procedure
.
.
will stop flashing and will be registered for
.com
TM3r TM3S
Pattern of the program
Pattern that is affected
by the SV limit function
TM2r TM2S TM3r
.
key for two seconds.
SEL
information@itm.com