Table of Contents
Advertisement
Ramp-soak control (Settings: oFF/rUn/hLd) (Option)
[Description]
• This function automatically changes the SV (Setting
value) according to the program pattern set in advance as
shown in the right line graph. Up to eight pairs of ramp-
soak operation can be programmed.
• The first ramp starts at the PV (Measured value) that is
the one just before running the program.
• The program can also automatically run at power-on
(Power-on starting function). Refer to the parameter of
(page 47).
Related parameters:
[Setting example] Starting the ramp-soak operation
Display
1.
2.
3.
4.
5.
6.
1.800.561.8187
18
(page 50)
to
(page 50)
to
(page 50)
to
(page 50)
(page 50)
(page 49)
Press and hold the
key for one second.
SEL
will be displayed on the PV display.
Press the
key to display
Press the
SEL
key once.
The current setting (
) flashes on the SV display.
Press the
or
keys to display
Press the
SEL
key once. Then, the program will start according to the ramp-soak pattern that is
set in advance.
If you want to display the operation status, press and hold the
www.
Up to SV-8
SV-3
SV-2
SV-1
SV-4
PV
First ramp
TM1S
TM2S
TM1r
TM2r
Ramp: the section in which the SV changes toward the target value.
Soak: the section in which the SV is the target value, and remains unchanged.
Operating procedure
.
SEL
.com
Fourth soak
TM3S
TM4S
TM3r
TM4r
Up to TM8r
key for two seconds.
information@itm.com
Up to TM8s
Hide quick links:
Advertisement
Table of Contents
