Decimal Point Position - FE PXR4 Operation Manual

Decimal point position (Settings: 0 / 1 / 2)
[Description]
• This parameter is used for selecting the number of decimal
point positions for the PV (Measured value).
"0" (No digit after decimal point)
"1" (1 digit after decimal point)
"2" (2 digit after decimal point. This is valid only for the voltage and current inputs)
[Setting example] Changing the decimal point position setting from 0 to 1
Display
1.
2.
3.
4.
5.
6.
1.800.561.8187
42
Press and hold the key for three seconds.
SEL
will be displayed on the PV display.
Press the key to display
Press the key once.
SEL
The current setting ( ) flashes on the SV display.
Press the
key to display .
Press the SEL key once.
controller will operate with one decimal point position displayed.
If you want to display the operation status, press and hold the
www.
Related parameters:
Operating procedure
.
will stop flashing and will be registered for
.com
(page 40)
(page 40)
. After that, the
SEL key for two seconds.
information@itm.com