Ramp-Soak Status Display; 1St To 8Th Target Sv; 1St To 8Th Ramp Segment Time; 1St To 8Th Soak Segment Time - FE PXR4 Operation Manual

Ramp-soak status display (Display only)
to
to
to
Ramp-soak modes (Setting range: 0 to 15) (Option)
[Description]
• By these parameters, the SV (Set value) are automati-
cally changed over time according to the patterns set in
advance as shown in the figure below. A maximum of 8
ramp-soak segments can be set in PXR.
• The first ramp starts from the PV (Measured value) just
before performing the program.
• The program can also be started at power-on automati-
cally (Power-on start function).
• A maximum of eight ramp-soak segments can be set. It
is also possible to set 4 ramp-soak segments twice in-
stead.
• When the following parameters are changed under ramp-
soak operation, operation will change the patterns of the
ramp-soak pattern is changed to the new setting.
•
•
•
•
SV
Up to SV-8
SV-3
SV-2
SV-1
SV-4
1st
ramp
TM1r TM1S
1.800.561.8187
50
1st to 8th target SV (Setting range:
1st to 8th ramp segment time (Setting range: 0 to 99h 59min) (Option)
1st to 8th soak segment time (Setting range: 0 to 99h 59min) (Option)
to
to
to
2nd 2nd 3rd 4th
1st 3rd 4th
soak ramp soak ramp soak ramp soak
TM2S TM3S TM4S
TM2r TM3r TM4r
4 ramp soaks (PTn=1)
8 ramp soaks (PTn=3)
www.
[Parameters]
In order to execute these functions, it is necessary to set
the programs in advance. To set the programs, set the SV
(Setting value) and time desired for the parameters shown
in the table on next page.
Related parameters:
SV-8
SV-6
SV-7
SV-5
Time
Up to TM8S, TM8r
4 ramp soaks (PTn=2)
.com
to ) (Option)
(page 49)
(page 18)
(page 54)
(page 54)
information@itm.com